TK50 ESP Multi-Function Unit for RC Tank

TK50 ESP series RC tank Gaming Controller

World's First integrated RC tank controller with Ultrasonic ESC

THIS IS NOT 100% PLUG AND PLAY BOARD, SIMPLE CHANGE IS NEEDED FOR FULL OPTIONS

(specifications and design are subject to change without notice)

Overview

• TK50 series controller is the successor of successful TK50 controller, uses 4-CH conventional PWM or 10-CH  S.BUS  RC system to control R/C tank's forward/backward movement, sharp turning, pivoting, turret rotation and gun barrel evaluation at variable speed

• Ultrasonic ESC*3  for two track motor and turret rotation

• Carefree reversing

• Ultra Low turn-on resistance FET for track motor ESC

• Support Gun Barrel Stabilizer ( G2 Variant )

• 22KHz, 8-bit high quality sound with digital sound mixer

• Maximum of 5 channel of sound track, main gun, machine gun, turret rotate, gun barrel elevation and engine sound can be generated at the same time

• 7W sound output power, 8/4-Ohm Speaker is recommended

• 0.8A BEC

• EPM*2 for gun elevation(EPM1) and turret rotation/gun traverses(EPM2) 

• Wide operating voltage rage, from 7.2 to 12V, support  3S Li-Po battery

• Support air-soft gun with sound synchronization

• Support TAMIYA and HL IR battle unit and format

• Support RealRecoil servo port

• Support Recoil Solenoid for 2nd Machine Gun( MG2 )

• G variant Support gun barrel stabilizer

• Safety shutoff prevents unwanted movement while signal lost

• Miniature design(60mm X 50mm X 20mm) for 1/25~1/16  R/C Tank

• V2 Engine Sound Simulation

• V2 Smoker driver

• Adjustable Low Battery threshold

• Adjustable ESC start voltage

• Extend sound effect ( for E variant )

Terminology

Ultrasonic ESC is the ESC block which switch FET at ultrasonic speed, make motor rotation extreme  smooth and quite. start voltage of ESC can also be adjusted for different type of motor.

Adjustable ESC start voltage: offset can be added to ESC input vs. output curve to meet the characteristic   of motor

Carefree reversing: Unlike some other control board, there is no need for TK series board to delay before being commanded to reverse, can go from full forward immediately to full reverse or vice versa
 

EPM ( ESC/PWM module) is peripheral which can be switched to ESC or PWM mode, allows the user to drive brushed motor or servo motor, in ESC mode, ESC port is enabled, can be used to drive brushed motor, In PWM mode, PWM port is enabled to driver servo motor, sound effect stopped when servo motor reach end point, TK50 has 2 EPMs for gun elevation(EPM1) and turret rotation/gun traverses(EPM2),

RealRecoil allows you to recreate real gun barrel recoil movement with single & cheap servo motor

Recoil Solenoid allows you to recreate MG/Auto cannon barrel recoil movement with Solenoid

V2 Smoker driver smoker fan/compressor speed is proportional to engine RPM and Load

V2  Mixer turning is achieved by reducing track speed and also increase opposite track speed to achieve smoother turning.

Adjustable Low Battery threshold cut off ESC output when battery voltage is lower than threshold, and threshold can be adjusted according to type and cells

Extend sound effect ( for E variant ) allows you to play 8 audio/music/voice

Momentum Effect to simulate inertia of tank hull movement

Product Identification System

you will need the FlySky FSi6S radio (S-bus) this comes with a 6 channel receiver, works perfectly with the TK50S, TK80S etc.
if you have this exact radio, just get a 6 channel iA6B receiver.

https://www.rctanklegion.com/collections/radio-transmitter/products/flysky-i6s-transmitter-and-receiver-set

more information:

http://www.clark-model.com/eng/index_e.html